38 thoughts on “ Problems Powering Raspberry Pi From GPIO Header ” thantik says: September 4, 2012 at 11:10 am Typo in article – his USB ports were reading 4v. Report ...

However, there aren't many astronomy apps and devices that also look good as a set piece in your living room. Fortunately, ...

While I typically try to keep my tinkering focused on practical purposes, sometimes I just have to pull a good prank ...

Waveshare has recently introduced the L76K GPS HAT, a Raspberry Pi-compatible HAT that supports multiple GNSS systems, ...

The GPIO pins on the Raspi are arranged in a 2×13 header. Until Sparkfun manages to manufacture a decent Raspi protoboard, the easiest way to break these pins out is with an old IDE ribbon cable.

The Raspberry Pi Opto-pi board has been created to make interfacing with the 8 digital GPIO pins on the Raspberry Pi mini PC much easier. Allowing you to connect higher current devices as well as ...

For this project, you'll need a set of Etekcity remote switches, a set of 433MHz RF Tx and Rx chips (Leland used SMAKN brand chips from Amazon), a Raspberry Pi (any model with GPIO pins should ...

If the Pi's size is of key importance, its GPIO header is a defining quality. It's the interface between the computer and tons of peripherals, accessories, sensors, and hacked-together gadgets ...

Raspberry Pi 5, with upgraded everything, ... a Gigabit Ethernet controller, camera and display interfaces, and GPIO, with all of it connected back to the AP by PCI Express.

New in time for the holidays is the Raspberry Pi 500, ... Bluetooth 5.0 connectivity, and a horizontal 40-pin Raspberry Pi GPIO connector. ...