The final PWM output of the module is at 5V level because the driver transistors are powered by onboard 5V/30mA LDO voltage regulator. Anyway, a simple cut in one circuit track will make it ready for ...

Renesas Electronics Corporation has introduced the RA2T1 microcontroller group based on the Arm Cortex-M23 processor, ...

Kinetic Technologies™ Announces New Active-Clamp Current-Mode PWM Controller for Up to 80V Input, 200W Output. ... an output range from 0.55V to 6V, the KTB8375 emplo... Back to Newsroom ...

The microcontroller’s PWM output drives the inverter with a 1-kHz, 50%-duty-cycle, 0 to 5V waveform. When the PWM output is 5V, it charges C 1.The lower diode in D 1 biases in a forward mode to ...

Murata has got together with German chip firm ZMDI to produce the Power Block, a small (13x17x11mm) module that includes all the components necessary to make a non-isolated 25A step down dc-dc ...

The output is proportional PWM, so note the frequency changes (about 6 MHz at 50% and 1.5 MHz at 12.5%). These numbers make sense because the base clock on the FPGA is 12 MHz.

In such cases the PWM input to the DrMOS module will be compatible with 3.3V rather than 5V. To accommodate different inputs, beginning with Rev 3.0 some DrMOS modules, including AOZ5006, are ...

For PWM drives up to 30 A rms output current, the power analyzer can be wired directly into the drive output. For currents above this level, an external shunt or current transducer may be required.