Therefore, proper and careful PCB layout is needed. The current loop can be closed by sensing the inductor current through a sensing resistor, the inductor DCR voltage drop, or the MOSFET conduction ...

Debuting as the newest member of the CONEX integrated stage and controller family, the CONEX-AGP is preconfigured with an Agilis AG-LS25-27P linear stage that integrates a direct ...

UNDERSTANDING CLOSED-LOOP FAN SPEED CONTROL By Ken W. Gay, SMSC When implementing cooling solutions for electronic equipment, ... The linear control algorithm, illustrated in Figure 3a, ...

There should be a minimum of 0.20 vpdd to reach a reasonably linear control loop. It is also possible to manage control valve characteristic requirements through the valve positioner. Control valve ...

The control loop must have sufficient gain and bandwidth to quickly adjust the duty cycle up or down as the FET transitions on and off. The output voltage swings between 10.5 volts and below 0.1 volt, ...

If you need to control the position of a machine to better than 0.100” linear position or the shaft of the motor within 5 deg, you must specify precise speed regulation.

New Scale Technologies Inc.'sminiature M3-L closed-loop linear motion module has a 0.5 micron positionresolution and a total package size of less than 27.5 x 13 x 7.5 mm. All motionand control ...

Figure 9 depicts a reactor vent pressure control loop, with the valve position used to control overhead pressure on the reactors. When the loop was in the auto mode it cycled strongly. Similarly to ...

If you wanted to, say, control a temperature you might think you could just turn on a heater until you reach the desired temperature and then turn the heater off. That sort of works, but it is subo… ...