Hi, I'm getting a compilation error using Adafruit_NeoPixel 1.15.1. This error does not occur on 1.15.0 and below. /Users/hkhan/Documents/Arduino/libraries/Adafruit ...

The Arduino Nano is powered by an Atmel ATmega328. It's an 8-bit AVR microcontroller that operates at a clock speed of 16 MHz and comes with 2 KB SRAM, 1 KB EEPROM, and 32 KB flash memory.

Nano ESP32: Runs on an ESP32 microcontroller and higher memory. Nano RP2040 Connect: Uses a Raspberry Pi RP2040 microcontroller and includes Wi-Fi, Bluetooth, an IMU, and a temperature sensor.

Kevin Santo Cappuccio has introduced a modern twist with his jumper less breadboard design, utilizing 12 analog cross point switches beneath the PCB to establish connections. These CH446Q 8x16 analog ...

Arduino Nano RP2040 features a dual-core 32-bit Arm Cortex-M0+ processor and is accompanied by a U-blox Nina W102 module for Wi-Fi and Bluetooth connectivity. An onboard accelerometer, gyroscope, RGB ...

GND should go to GND, 5V to 5V, and Signal to pin 7. 3. Connect to Mains Connect the Arduino to mains using a phone adapter. Starting from the moment you plugged it ib, it will keep counting in ...

My goal was to use this with the ArduinoBLE library. I started with a git pull (today) of this (linux host), blink worked, then I added only the ArduinoBLE library. Observed behavior is that BLE.begin ...

Cytron Maker Nano RP2040 is board similar to Raspberry Pi Pico but with Arduino Nano form factor, a proper reset button, two RGB LEDs, single color LEDs for some GPIOs, a buzzer, as well as two ...