Plug the RFID module into the breadboard with enough space around it. Connect the VCC pin to the Arduino's 3.3V (not 5V), and GND to the ground rail. For the data connections, wire SDA to Pin 10, SCK ...

LoRa now supports mesh networking thanks to Meshtastic, an open-source platform enabling secure, low-power, long-range ...

No debug messages are shown on the serial monitor, even with sketches known to work on ESP32-S3. Tried multiple cables, ports, and host PCs. Connect the ESP32-S3 board via USB-C to a Windows 10 PC.

You can find the wiring diagram here or check out the image ... Source: Mr. Innovative/YouTube Now, grab your Arduino Nano, plug in the USB cable, and upload the code that will make your DIY ...

RA2L2 low-power MCUs are the industry’s first MCU to support USB-C Revision 2.4 with 15W CC detection, USB FS, CAN, I3C, and low-power UART.

Hi, I'm Bill. I'm a software developer with a passion for making and electronics. I do a lot of things and here is where I ...

In just 100 seconds, learn how Arduino works - from its microcontroller and architecture to how it's programmed and used in ...

Arduino UNO SPE Shield adds Single Pair Ethernet (SPE) and RS485 to Arduino UNO and compatible boards, notably the Arduino UNO R4, via a Microchip LAN8651 SPE controller. Single Pair Ethernet relies ...

What is Arduino Serial Data Viewer? Arduino Serial Data Viewer was created in response to a lack of simple tools that enable rapid bootstrapping and development of data-centric Arduino projects. The ...