I have used Red and Green LED’s. When node A is positive green LED glows while when node B is positive, Red LED glows. This indicates polarity of the input d.c voltage . 2) LED as a Continuity tester: ...

This Design Idea describes a simple LED-lighting-effects circuit comprising only five chips and costing only a few dollars. When you first observe the circuit in action, you will think that it uses a ...

The datasheet confirms this current, which is less than 0.5 mA but sufficient to light a high-brightness LED to an unacceptable degree. The indication was not “sharp” enough for me.

LED lighting is more of an art than a science. There are myriad of LED types from which to choose and varying ways to arrange them. This gives room for lots of creativity.

For under $20 you can get a LED tester (look for TV back light tester) that’ll test anything from IR LEDs @ 1.2v up to 300v. Not sure why so high when TV back lights are usually around 100v.

This boost circuit implements current mode control and senses the LED current via resistor R14. The output voltage is boosted to just over 30V to drive 10 LEDs at a regulated current of 0.35A. Often, ...

Building simple circuits with copper tape, LED bulbs, resistors, and watch batteries is not as simple as you might think. Notre Dame Elementary School STEM students are putting the engineering desi… ...

I added the same lights to my Honda Deauville. Used a pair of relays and a dimmer circuit. Relay 1 taps the rear brake light (always on) and routes the power through the dimmer then the NO of relay 2.

INDIANAPOLIS — Welcome to Home Zone! Today, we’re upgrading outdoor lighting with an easy and modern solution — plug-in LED lights. If you’ve been dealing with old, unreliable transformer ...