Hi, I'm getting a compilation error using Adafruit_NeoPixel 1.15.1. This error does not occur on 1.15.0 and below. /Users/hkhan/Documents/Arduino/libraries/Adafruit ...

Unlike the classic Arduino Nano R3, the Nano RP2040 Connect comes with a human interface device (HID) feature that essentially converts it into a mouse or keyboard when connected to the computer.

The Arduino Nano is powered by an Atmel ATmega328. It's an 8-bit AVR microcontroller that operates at a clock speed of 16 MHz and comes with 2 KB SRAM, 1 KB EEPROM, and 32 KB flash memory.

Simply connect the moisture sensor and the water pump (through the relay) to the Nano RP2040 Connect board, insert the moisture sensor in a flower pot, and put the pump in a recipient filled with ...

The hardware is based around the Arduino Nano RP2040 Connect, a board that brings the Raspberry Pi RP2040 microcontroller to the Nano form factor. Arduino Nano RP2040 features a dual-core 32-bit Arm ...

GND should go to GND, 5V to 5V, and Signal to pin 7. 3. Connect to Mains Connect the Arduino to mains using a phone adapter. Starting from the moment you plugged it ib, it will keep counting in ...

My goal was to use this with the ArduinoBLE library. I started with a git pull (today) of this (linux host), blink worked, then I added only the ArduinoBLE library. Observed behavior is that BLE.begin ...

The Arduino Nano RP2040 Connect is “Raspberry Pi Compatible”, meaning that it has not only support for the entire RP2040 software ecosystem but also full support for MicroPython. At the same time, the ...