The long, solder-heavy way to get root access to a Starlink terminal Zapping the satellite board at just the right time can grant deeper access. Kevin Purdy – Nov 14, 2022 2:31 pm | 53 ...

3D printed solder stencil on PCB, after applying solder paste. [Jan] says that the printed stencil had a few defects but it otherwise worked fine for 0.5 mm pitch ICs and 0402 resistors, ...

Designing PCBs with terminal blocks requires an understanding of the types of terminal blocks available, the best way for them to be packaged for delivery, and how to solder them ...

Holding the PCB at 125°C for example is a complete non-issue: 150Tg or 170Tg have this as an actual operating temperature. Don’t hold your PCB at 125°C for 2000 hours or so, but 10-30 minutes ...

Offers Right-angle M12 Connectors for Through-hole Reflow Soldering Processes . Phoenix Contact now offers right-angle M12 ...

2-position PCB terminal (All Electronics #TER-202; $0.45) 8-ohm 1-inch speaker ... Route all the circuit’s +9-volt connections to one pin of the two-position PCB terminal and solder them together.

Connectors can be attached, removed, and reattached to the PCB up to 500 time without damaging the PCB, it claimed. Recommended board thickness is 0.04 to 0.1inch (~1-2.5mm) and recommended screw ...