While I typically try to keep my tinkering focused on practical purposes, sometimes I just have to pull a good prank ...

The Raspberry Pi is a great machine to learn the ins and outs of blinking pins, but for doing anything that requires blinking pins fast, you’re better off going with a BeagleBone.This has been ...

38 thoughts on “ Problems Powering Raspberry Pi From GPIO Header ” thantik says: September 4, 2012 at 11:10 am Typo in article – his USB ports were reading 4v. Report ...

Argon ONE UP is a 14-inch laptop powered by a Raspberry Pi Compute Module 5. It boasts ports, expansion ports, and 40 pin ...

Most GPIO capabilities become user-friendly by code libraries written to simplify options, but some simplifications are built right into the Raspberry Pi GPIO pins themselves.

Argon40, a company known for its cases for Raspberry Pi computers, is expanding its product line with a new device, the Argon ONE UP, which is actually a full-fledged laptop power ...

The Raspberry Pi Opto-pi board has been created to make interfacing with the 8 digital GPIO pins on the Raspberry Pi mini PC much easier. Allowing you to connect higher current devices as well as ...

For this project, you'll need a set of Etekcity remote switches, a set of 433MHz RF Tx and Rx chips (Leland used SMAKN brand chips from Amazon), a Raspberry Pi (any model with GPIO pins should ...

Raspberry Pi 5, with upgraded everything, ... a Gigabit Ethernet controller, camera and display interfaces, and GPIO, with all of it connected back to the AP by PCI Express.

While most modern laptops have user-accessible storage, allowing you to remove and replace the SSD, and some also have ...